Need help?Do you have a question about the Minelab SDC 2300 and is the answer not in the manual?
General| Type | Gold Detector |
|---|---|
| Collapsible | Yes |
| Target ID | No |
| Ground Balance | Automatic |
| Technology | Pulse Induction |
| Waterproof | Yes, up to 3 meters |
| Coil Size | 8-inch round |
| Audio Output | Internal speaker or headphones |
| Length Extended | 1500 mm |
| Display | No |
| Battery Life | Up to 8 hours |
| Coil Type | Monoloop |
Instructions on how to collapse and store the detector.
Guide to properly insert Lithium-Ion or alkaline batteries.
Procedures for charging the Lithium-Ion battery using AC or car charger.
How to connect headphones to the detector and headphone warnings.
Step-by-step guide for initial setup and detecting.
Visual indication of target size, proximity, and battery status via LEDs.
How to check the current battery level using the detector's controls.
Procedure to minimize electrical interference for a clearer signal.
Setting the background audio level for optimal target detection.
Compensating for ground mineralisation using Automatic Ground Tracking.
Selecting modes and adjusting sensitivity for different ground conditions.
Choosing between Low Pitch and High Pitch audio settings.
Guidance on identifying potential gold-bearing areas and soil conditions.
How to distinguish target signals from ground noise and other effects.
Ensure coil is close and parallel to the ground for optimal depth and response.
Adjust sweep speed and sensitivity for best performance and target detection.
Dig all signals and keep metal away from coil to avoid false signals.
Listen carefully to audio cues and maintain a positive attitude for successful detecting.
Specifies the fundamental operating frequency of the detector.
States the detector's intended use and limitations.
Informs about potential variations and updates to the detector.
To Next Page
