Minelab SDC 2300 User Manual

3
Setting Up
1. Release armrest strap
Loosen the armrest strap and slide off of the
coil pivot to release the shaft assembly.
2. Fold out coil/shafts
Fold the coil/shaft assembly out until it clicks
into place.
3. Slide up handle assembly
Slide the handle assembly forwards and
upwards until it clicks into position. This will also
lock the shafts.
4. Extend and open armrest
Slide the armrest backwards until it stops. Open
the armrest wings outwards.
5. Rotate coil into position
Rotate the coil forwards 180° in line with the
shafts. Turn the coil 90° so that it is horizontal.
6. Extend shafts
Unlock the upper and lower camlocks and
extend the middle and lower shafts to a
comfortable detecting length. Lock the upper
and lower camlocks.

Minelab SDC 2300 Specifications

General

Type	Gold Detector
Collapsible	Yes
Target ID	No
Ground Balance	Automatic
Technology	Pulse Induction
Waterproof	Yes, up to 3 meters
Coil Size	8-inch round
Audio Output	Internal speaker or headphones
Length Extended	1500 mm
Display	No
Battery Life	Up to 8 hours
Coil Type	Monoloop