T1 20.5
20
20-620-6
20-620-6
20-6
TROUBLES - CAUSES - WHATROUBLES - CAUSES - WHA
TROUBLES - CAUSES - WHATROUBLES - CAUSES - WHA
TROUBLES - CAUSES - WHA
T TO DOT TO DO
T TO DOT TO DO
T TO DO
The machine has been tested at factory therefore it must perfectly operate.
A wrong use of the machine might cause some troubles.
TROUBLETROUBLE
TROUBLETROUBLE
TROUBLE
The machine does not start
CAUSECAUSE
CAUSECAUSE
CAUSE
WHAT TO DOWHAT TO DO
WHAT TO DOWHAT TO DO
WHAT TO DO
No power on one phase or more phases Make sure that the 3 phases are hot
Fuses of auxiliary circuit interrupted or Close the housing of fuses; if the machine
housing of fuses open. does not start:
- open the housing
- check the fuses, if necessary replace them (a set
of fuses is supplied in the accessories bag).
Door open Close the door so that it is in contact with the safety
microswitch.
The microswitch serves for stopping the spindle
when unintentionally you open the door or during
the belt change.
Emergency button on Turn the emergency buttons.
TROUBLETROUBLE
TROUBLETROUBLE
TROUBLE
The machine stops during the working
CAUSECAUSE
CAUSECAUSE
CAUSE
WHAT TO DOWHAT TO DO
WHAT TO DOWHAT TO DO
WHAT TO DO
No power on one phase or more phases Make sure that the 3 phases are hot
CAUSE
Fuses of auxiliary circuit interrupted or Close the housing of fuses; if the machine
housing of fuses open does not start:
- open the housing
- check the fuses: if necessary replace them (a set
of fuses is supplied in the accessories bag).
Too heavy working to the motor power. Wait until the motor overload cutout on the control
board or inside the electric cubicle is cold.
To Next Page
Loading...
