MKA-42 OR MKA-52/62
QUICK RELEASE BRACKET
1862014 & 1862016
Item /
Assembly
Part # Description Qty.
A
Includes 2-6
2994829 BAG ASSY-MAX QUICK RELEASE 1
2 2073408 SCREW-1/4-20 X 7/8 PPH S/S 6
4 2261713 WASHER-1/4 FLAT 18-8 SS 6
6 2263103 NUT-1/4-20 NYLOCK SS 12
8 2500000 SCREW-1/4-20 X 2 1/4 PPH S/S 12
B
Includes 10-16
✖
QUICK RELEASE MNT STD ASSY *MKA-42* *SHORT* 1
C
Includes 10-16
✖
QUICK RELEASE MNT LG ASSY *MKA-52/62* *LONG* 1
10
✖
SLIDE PLATE 1
12
✖
BASE PLATE 1
14 2370101 THUMB SCREW 1
16 2371718 LOCKWASHER-1/4” ZINC 1
p
2374911 INSTR SHEET-MAX QUICK RLS. 1
The MKA-42 and MKA-52/62 are recommended for use with all Minn Kota
®
Fortrex
®
, Maxxum
®
, Edge, and Ultrex freshwater trolling motors.
p Not shown on Parts Diagram.
✖ This part is included in an assembly and cannot be ordered individually.
TOOLS AND RESOURCES REQUIRED
• Drill
• 9/32” Drill Bit
• #3 Phillips Screw Driver
• Awl, pencil or similar marking tool
• A second person to help with
the installation
MOUNTING CONSIDERATIONS
It is recommended that the motor be mounted as close to
the centerline of the boat as possible. The motor must not
encounter any obstructions as it is lowered into the water or
raised into the boat when stowed and deployed. Make sure the
motor rest is positioned far enough beyond the edge of the
boat. Make sure the area under the mounting location is flat,
clear to drill holes and install nuts and washers.
1212
1010
22
AA
BB
CC
44
66
88
WARNING
For motors with Lift Assist (Fortrex and Ultrex), the lift
cylinder should be disengaged until installation is complete
to prevent injury.
NOTICE: For Ultrex motors, please review the “Disconnect
the Gas Spring” section of the Ultrex Owner’s Manual
(#2297160) online at minnkotamotors.com.
NOTICE: For Fortrex motors, please review the
“Disconnect the Gas Spring Pin” section of the Fortrex
Owner’s Manual (#2287100) online at minnkotamotors.com.
Complete Typical Installation
1414
1616
1 | minnkotamotors.com
©2020 Johnson Outdoors Marine Electronics, Inc.
To Next Page
Need help?
General
