19
Dowel Drill Manual
OPERATIONS MANUAL
Be sure lubricator is full. See recommended oils below.
Make sure slab wheels are square against face of slab.
Using feed control valve, feed bit against slab.
Using drill control valve, turn drill on and drill until the
drill slider is against the stop clamp, which should be
set for the required depth of hole.
Once drill slider is against the stop clamp, leave the
drill on and use the feed control valve to retract the
drill from the hole. Note: If bit will not retract from hole,
feed drill back into hole and retract drill again.
Step 1
Step 2
Step 3
Step 4
Step 5
Bio-Rock Drill™ Oil 15W50
Renewable
Lubricants
To Next Page
Loading...
