E11E10
Checking Batteries
The low-battery lamp will light or blink on the control panel
when the batteries are low.
We recommend replacing the batter-
ies. The low-battery lamp at the
rear of the unit is lit when batteries
are low, but flash can be used.
When the low-battery lamp
blinks at the rear of the unit, the bat-
teries need to be replaced. Flash
cannot be used. Insert new batteries.
• Check the orientation of the batteries if nothing glows when the flash
on/off button is pressed.
BATTERIES
INSTALLING BATTERIES
The 3600HS (D) may be powered by :
• Four AA-size alkaline batteries
• Four AA-size lithium batteries
• Four AA-size rechargeable nickel-metal hydride (Ni-MH) batteries
Always ensure that rechargeable nickel-metal hydride batteries are
charged in the specified charger unit.
1. Open the battery-chamber door as shown.
3. Close the battery-chamber
door.
• The indicator lamps are lit on the
control panel. Press the flash on/off
button if it is not lit.
2. Insert the batteries according
to the diagram in the battery
chamber.
To Next Page
Loading...
