Minolta DIMAGE SCAN DUAL III - Undoing, Redoing, and Tracking Corrections; Saving Image Corrections

6766
Image corrections can be stored temporarily as a thumbnail next to the displayed
image. Simply click the snapshot button on the tool bar to create a thumbnail with
the current image corrections.
To return to a previous
image correction, click on
the corresponding snap-
shot thumbnail. The thumb-
nail image will replace the
displayed image. The num-
ber of snapshots that can
be made is only limited by
the computer memory.
To delete a snapshot, click
on the thumbnail and press
the keyboard delete key
(Windows), or command
and D key (Macintosh).
The thumbnails will be
deleted when the software
is closed.
Snapshot display area
Tracking image corrections - Snapshot button
Undoing and redoing image corrections
Click the undo button to cancel the last image correction applied to the
image. The number of image corrections that can be undone depends on
the computer memory capacity.
Click the redo button to reapply the last image correction canceled with the
undo button.
Click the reset-all button to cancel all image corrections applied to the
image.
The undo, redo, and reset-all buttons only affect tools used in the image-correction
tab.
Comparing pre and post correction images
Clicking the comparison display button divides the image display area in two. The
original image is on the left and the corrected image is on the right. To display the
corrected image only, click the comparison display button again.
Original image Corrected image
Changes made with the scroll bars on one image will be applied to the other. Using
the fit-to-window button automatically resizes both images to fit the display area.
Saving image corrections
All corrections applied to an image can be saved as an image-correction Job. The
Job can be loaded into the utility at any time and applied to different images. This is
a time-saving function when a large number of images need too be processed with
the same correction settings.
Click the save image-correction Job button
to save the current image-correction set-
tings.
Enter the Job name. Click OK to save the
settings.
DIMAGE SCAN DUAL III UTILITY - IMAGE PROCESSING