D-93
(14) Adjustment of Edge Erase
z
Requirement
1136D043AA
z
Important
This adjustment must be made after the “adjustments of reference positions”.
1136D044AA
1134D114AA
D
Dimension A, which is the erase width from the front edge on
the copy of the GTC-test chart, should be in the range be-
tween 0.5 mm and 4.0 mm.
1. Place the GTC-test chart face down on the Original Glass
and align its rear left corner with the reference marker on
the Original Width Scale. Then, lower the Original Cover.
2. Make a single copy on A3 or 11”
⋅
17” paper in full size
mode.
*If A3 or 11”
⋅
17” paper is not available, use A4 or 8−1/2”
⋅
11” crosswise paper.
3. If the front edge erase width deviates from the specifica-
tions, adjust as necessary by turning the Edge Erase Ad-
justing Screw.
D
If dimension A on the copy (of the original width of 3.0 mm)
is narrower than 0.5 mm, tighten the Adjusting Screw.
D
If dimension A on the copy (of the original width of 3.0 mm)
is wider than 3.0 mm, loosen the Adjusting Screw.
Adjusting Instructions
To Next Page
Loading...
