Why is the image too light on my Minolta EP2010 Copier?
The image might be too light on your Minolta Copier because the exposure level for the Auto Exposure Mode is set to a "Light" level, or the manual exposure level is set on the lighter side. You may also need to replenish toner, or replace the toner bottle if the Add Toner Indicator is lit. Damp paper can also cause light images, so replace the paper.
What to do if the image is too dark on my Minolta EP2010 Copier?
If the image is too dark, it might be because the exposure level for the Auto Exposure Mode is set to a "Dark" level, or the manual exposure level is set on the darker side. The Original Glass might also be dirty, or the original is not held tightly against the Original Glass. In the first two cases, change the exposure settings. In the last two cases, clean the Original Glass or ensure the original is placed correctly.
What to do if my Minolta EP2010 makes copies with dark specks or spots?
Dark specks or spots on copies from your Minolta Copier can be caused by a dirty Original Glass, Original Pad, or Document Feed Belt. Also, if the original is very thin or highly transparent, or if it's a two-sided original, it can cause dark specks. To resolve this, clean the glass, pad, or belt. For thin originals, place a blank sheet of paper over the original, or set the copier into the Manual Exposure Mode and make the exposure level lighter.
Why does the edge of the copy look dirty on my Minolta EP2010 Copier?
A dirty edge on copies from your Minolta Copier could be due to a dirty Original Pad or Document Feed Belt. It can also occur if you've selected a paper size larger than the original or if the original is not placed correctly. Ensure the Original Pad and Document Feed Belt are clean. Select the same copy paper size as the original or use the Auto Size Mode. Make sure the original is placed in the correct position and the paper drawer is loaded in the same direction.
How to align the image properly on a Minolta EP2010?
If the image on the copy is not aligned properly, ensure the original is placed correctly on the Original Glass, or load it onto the Document Feeder correctly along the Document Guide Plates. If using the Document Feeder, the originals may not be suitable for it; try placing the originals on the Original Glass one at a time.
Why does my Minolta EP2010 Copier make copies with lines?
If your Minolta Copier is producing copies with lines, the Corona Units may be dirty. Clean the Corona Units using the Corona Unit Cleaning Levers.
What to do if the Control Panel shows nothing on my Minolta EP2010?
If the Control Panel shows nothing, but the Start Key is lit up green, the copier is in Energy Saver Mode. Press any key on the Control Panel to cancel the Energy Saver Mode. Alternatively, the copier might be in Auto Shut OFF Mode, in which case you should turn the Power Switch ON.
What to do if my Minolta EP2010 doesn't feed copies when pressing the Start Key?
If no copies are fed out when the Start Key is pressed, the Wait Indicator might be lit up, meaning the copier is warming up. Please wait. Alternatively, the Warning Indicator might be lit up. Check the Control Panel and take action according to the particular Indicator.
What to do if Control Panel Keys do not respond on my Minolta EP2010 Copier?
If the Control Panel Keys do not respond, the Interrupt Key LED might be lit up, indicating that the copier is in interrupt mode. Press the Interrupt Key to cancel the interrupt mode.
What to do if my Minolta EP2010 Copier is not activated when the Power Switch is turned ON?
If the copier is not activated when the Power Switch is turned ON, check if the power cord is plugged into the power outlet and plug it in if it isn't. Also, check if the room circuit breaker is open and close it if necessary.
To Next Page
General
