Minolta EP2010 - When the Call-Tech.-Rep. Indicator Lights up

6. When the Call-Tech.-Rep. Indicator Lights Up
A3
A4
A4
Auto
Photo
Lighter Darker
A
0.5~2.0
A4
Full Size
A3
Full Size Paper
B4 A3
B4 A4
A3 A4
A5
Auto
Auto / Photo
1151O076DA
When a malfunction occurs in the copier, the
Call-Tech.-Rep. Indicator lights up and the
corresponding malfunction code appears across
the Zoom Ratio Indicator and Multi-Copy
Display. At this time, the Start Key turns to
orange and you cannot start a new copy cycle.
Try to clear the Call-Tech.-Rep. Indicator by
following the instructions below.
Resetting the Call-Tech.-Rep. Indicator
Open the Front Door, then close it.
This will reset the Call-Tech.-Rep.
Indicator.
1
Carry out this procedure with the
Power Switch turned ON.
NOTE
◆If the Call-Tech.-Rep. Indicator lights up
again, call your Technical Representative
immediately.
•
When calling your Technical
Representative, give him or her the
malfunction code shown across the
Zoom Ratio Indicator and Multi-Copy
Display.
<Example> Malfunction Code: C0010
•
After calling your Technical
Representative, turn OFF the Power
Switch and unplug the power cord.
NOTES
1151O066AA
0.5~2.0
1151O066AA
Chapter 5
When an Indicator Lights up
77