Minolta EP2010 - When the Add Staple Indicator Lights up

3. When the Add Staple Indicator Lights Up
A3
A4
A4
B4
FLS.
Inch
Auto
Photo
Darker
A
0.5~2.0
Auto
A4
Full Size
A3
Full Size Paper
B4 A3
B4 A4
A3 A4
A5
1151O073DA
Auto
/ Photo
1151O073DA
When the staples will soon run out, the Add
Staple Indicator lights up.
Replace the Staple Cartridge with a new one by
following the procedure given below.
Open the Stapler Door.
2
1139O0490A
1139O2190A
While lifting the Lever upward, pull
the Staple Cartridge out of its port.
3
1139O1350A
Insert the new Staple Cartridge until it
clicks into position.
5
Close the Stapler Door and slide the
Staple Sorter back against the copier.
6
1139O1440A
Press the Lock Release Lever of the
Staple Sorter and slide it away from
the copier.
1
Pull the staple belt about 1" out of the
new Staple Cartridge and break off that
portion.
4
1139O0970A
Check that no portion of the staple belt
hangs out of the Cartridge. Break off
any portion of the belt that hangs out of
the Cartridge.
NOTE
Replacing the Staple Cartridge
Chapter 5
When an Indicator Lights Up
64