Symptom Check for: Action
The Control Panel shows nothing. Is only the Start Key lit up green? The copier is in the Energy Saver
Mode.
Press any key on the Control Panel
to cancel the Energy Saver Mode.
➭
p. 17
The copier is in the Auto Shut OFF
Mode.
➭
p. 16
Turn the Power Switch ON.
No copies are fed out when the
Start Key is pressed.
The Wait Indicator is lit up. The copier was just turned ON and
is warming up. Please wait.
The Warning Indicator is lit up. Check the Control Panel and take
action according to the particular
Indicator.
➭
p. 59
Control Panel Keys do not respond. The Interrupt Key LED is lit up. The copier is in the interrupt mode.
Press the Interrupt Key to cancel
the interrupt mode.
➭
p. 16
The copier is not activated when
the Power Switch is turned ON.
The power cord is left unplugged
from the power outlet.
Plug the power cord into the power
outlet.
The room circuit breaker is open. Close the room circuit breaker.
*
If these procedures do not correct the problem, turn OFF the Power Switch, unplug the power cord
from the power outlet and contact your Technical Representative.
2. The Copier is not functioning as designed
Interrupt
1139O2602A
Chapter 6
Troubleshooting
88
To Next Page
Loading...
