Misfeed Clearing Procedures
Copier (Fusing/Transport Section)
Be careful not to touch the areas
marked with High Voltage and
Caution: HOT with bare hands.
NOTE
Open the Front Door. Turn the Lock
Release Lever counterclockwise to
unlock and swing up the Upper Half of
the copier. Then lock Stopper M2 .
1
1151O113AA
Holding up the Fusing Unit, pull out
the sheet of paper in the direction of
the arrow.
2
Remove any sheet of paper from the
Transport Section.
3
Slightly lift up the Upper Half of the
copier and unlock Stopper M2 .
Gently swing down and lock the Upper
Half of the copier. Then, close the Front
Door.
4
1151O144AB
5. When the Misfeed Indicator Lights Up
CAUTION : HOT
The Fusing Unit and its surrounding
areas may be extremely hot. DO NOT
touch any part except the Fusing Unit
Handle (yellow).
Chapter 5
When an Indicator Lights Up
69
To Next Page
Loading...
