Minolta EP2010 - Making the Users Choice Settings

NOTE
If you have pressed an incorrect
number, press the Clear Key, then
enter the correct number.
Multi-Copy Display
3. User’s Choice
Keep pressing the Panel Reset Key
for about 3 seconds.
* U is shown on the Zoom Ratio
Indicator.
1
Using the Key Pad, enter the desired
Choice Code number.
*The Choice Code number is shown
on the Zoom Raito Indicator.
2
Making the User’s Choice Mode Settings
Press the Start Key.
*This enters the choice code selection
and the current setting of the choice
code is shown on the Multi-Copy
Display.
3
Press the Clear Key.
*This clears the current setting (shown
on the Multi-Copy Display) of that
particular choice code.
4
1139O2360A
Press the appropriate Key Pad or
Pads to enter the new setting.
*The Multi-Copy Display shows the
new setting.
5
Panel Reset
1139O4782A
1139O4782A
1139O3850A
1139O3850A
Zoom Ratio Indicator
1139O3860A
1139O3860A
Multi-Copy Display
1139O3870A
1139O3870A
Zoom Ratio Indicator
1139O3880A
1139O3880A
1139O3870A
1139O3870A
Zoom Ratio Indicator
1139O3880A
1139O3880A
Multi-Copy Display
123
456
789
0C
1139O2620A
1139O3870A
1139O3870A
Zoom Ratio Indicator
1139O3860A
1139O3860A
Multi-Copy Display
1139O3870A
1139O3870A
Zoom Ratio Indicator
1139O3890A
1139O3890A
Multi-Copy Display
Press the Start Key.
*This enters the new setting.
6
Repeat steps 2 to 6 to make new
settings for other User’s Choices.
Useful Tip
Press the Panel Reset Key.
*This allows the copier to leave the
User’s Choice Mode, and the control
panel shows the initial settings
again.
7
123
456
789
0C
1139O4860A
123
456
789
0C
1139O4870A
1139O4870A
Chapter 4
Special Functions
58