Minolta EP2010 - Inside the Copier

1
Lock Release Lever : Turn clockwise to swing up the Upper Half of the copier to clear a
paper misfeed.
2
Toner Bottle
Holder
: Swing open to replace the Toner Bottle.
➭
p. 63
3
Original Pad : Holds the original in position on the Original Glass.
4
Original Glass : Place the original face down on this Glass.
5
Corona Unit
Cleaning Lever
(Upper/Lower)
: Operate the Lever to clean the corresponding Corona Unit if unwanted
lines are produced on the copy.
➭
p. 95
6
Imaging Unit Lock
Release Lever
: Operate when replacing the Imaging Unit.
7
Dehumidifier
Switch
: Turn ON to prevent condensation from forming on the PC Drum when
power is turned OFF.
(For Technical Representative only
8
Fusing Unit Handle : Hold onto this Lever when lifting the Upper Half of the Fusing Unit.
➭
p. 69
Inside the Copier
2. Copier Parts and Accessories
1139O2040A
3
4
2
1
5
1139O1030A
7
8
6
Chapter 2
Getting to Know your Copier
9