3. Manual Bypass Copying
Use the Manual Bypass to make copies on paper not loaded in any Drawer, or to copy onto
transparencies, translucent paper, or any other special paper.
When using the Multi Bypass Tray, you can load multiple sheets of copy paper.
Copy Paper That Can be Used for Manual Bypass
◆Types of Paper
•
Plain paper (weighing 60g/m
2
to 90g/m
2
)
•
Thick paper (weighing 90g/m
2
to 157g/m
2
)
•
Transparencies, translucent paper
◆Paper Size
•
Max. Size: 297mm × 432mm
•
Minimum Size: 100mm × 140mm
◆Capacity of the Multi Bypass Tray
•
Plain paper ... Up to 50 sheets
•
Plain paper (once-copied paper) ... Up to 20 sheets
•
Thick paper, transparencies, translucent paper ... Up to 20 sheets.
Using the Multi Bypass Tray
Place the original on the Original
Glass and make the control panel
settings.
1
The following functions cannot be
selected for Manual Bypass:
Auto Paper, Auto Size, Book Copy, any
of the Finishing Modes, 2-Sided
Copying, and File Margin Mode.
NOTE
Swing down the Multi Bypass Tray.
Slide the Guide Plate to the size of
the copy paper.
∗ Slide the Multi Bypass Tray Extender out
when using large-size copy paper.
2
Load a neat stack of copy paper on the
Tray and insert it until it stops.
3
1139O0130A
• The paper should be loaded no higher than
the ▼ (Max. Level Indicator).
• Before inserting, fan the paper stack well if
you are using transparencies or translucent
paper.
• Correct any curl if you are using thick paper.
NOTE
1139O0140A
Chapter 3
Making Copies
28
To Next Page
Loading...
