D-33
1136D139AA
1136D140AA
A
1136D141AA
2mm or Less
1136D142AA
B
4. Pass the longer length of the cable through the hole in the
light blocking plate.
5. Slide the Cable Drive Gear onto its shaft and insert a
wrench into the hole (4-mm dia.) to position the gear.
6. Wind the shorter length of the cable around pulley A.
7. Secure the shorter length of the cable to the Cable Fixing
Bracket.
NOTE
Ensure a distance of 2 mm or less for the dimension shown
on the left.
8. Wind the longer length of the cable around pulley B.
9. Hook the spring onto the longer length of the cable and pull
the spring to hook it onto the shorter length of the cable.
10. Remove the wrench and peel off the two pieces of tape
used in steps 2 and 3.
To Next Page
Loading...
