D-86
4. Touch the shift key
A
or
"
to change the setting value.
5. Touch
Enter
to validate the setting.
D
If dimension A on the copy is longer than 11.5 mm, increase the setting value.
D
If dimension A on the copy is shorter than 8.5 mm, decrease the setting value.
*If the measurement does not fall within the specifications through one setting, try another
setting.
Setting Instructions
Touch This Key if Measurement is Longer.
Touch This Key if Measurement is Shorter.
1156D157CA
NOTE
Be sure to touch Enter before pressing the Panel Reset Key to return the copier to the Basic
screen. If this is not done, the old setting remains valid.
To Next Page
Loading...
