Minolta MND25 - Installing the Battery; Installing the Memory Card

2
.
First Use
9
2.
First Use
2.1 To Open the Battery Door
Unlock the battery door by sliding the battery door latch toward the center of
the camera. Use a fingernail or other pointy object when sliding the latch to
get a better grip. When the latch is fully open, the door will swing up.
2.2 Installing the Battery
Insert the lithium-ion battery into the battery compartment with the metal
contacts facing the inside of the camera. The battery can only be inserted
one way. To remove the battery, open the battery door and slide the
battery locking tab down and the battery will pop out.
2.3
Installing the Memory Card
Insert the included Micro SD memory card to record and store your videos
and photos. When the battery is low, media stored on the memory card will
not be erased. Please insert the SD memory card by following the steps
below:
1.
Ensure that the camera is powered off.
2.
Open the battery door to access the memory card slot.
3.
Insert the memory card. Ensure that the metal contacts are inserted first.
Push the memory card down until you hear an audible click.
The memory card can only be inserted in one way. Do not force the
card in if it will not go in smoothly.