2-17
Chapter 2Setting-Up
Setting-Up
Connecting to a Computer
Caution
Note
1
Make sure that the printer and the computer you are connecting
it to are both turned off.
2
Connect one end of the interface cable to the parallel port of the
computer.
3
Connect the other end of the interface cable to the parallel inter-
face connector on the back of the printer. Secure the interface
cable using the two clips on the parallel interface connector.
◆ Always use a shielded interface cable. Use of an unshielded cable can
result in radio interference with data.
◆
You must purchase an IEEE 1284 type-B cable for connection between
the printer and a computer. For detailed specifications of the interface
cable, see “Interface Connector and Cable” on page 8-6.
◆
Minolta does not warrant the use of any particular cable. The user
assumes all responsibility as to the quality and performance of the cable.
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
To Next Page
Loading...
