20 21
LOADING FILM
If 0 blinks in the data panel, press the film-
chamber release, open the chamber, then
remove the film.
- If the film’s current VEI is , insert film with the
or VEI current.
- If a processed roll of film was loaded into this
camera, the VEI has been changed from to
.
- If the film’s current VEI is or , remove the
film, remove and reinsert the battery, then reload
the film. If the film will not load, contact the
nearest authorized Minolta Service Facility.
• The data panel will display the cassette mark
and the film’s ISO, then the number of frames
remaining on the roll.
• If a partially-exposed roll of film (VEI ) is loaded
into this camera, the film will be advanced to the
first unexposed frame.
4. Press the film-chamber door closed until it clicks.
• After the film is loaded, pressing the film-
chamber release will display the film’s ISO in
the data panel. The display will disappear about
2 seconds after the finger is released.
The film chamber cannot be opened until the
film has been rewound.
To Next Page
Loading...
