68 69
REMOTE CONTROL (Sold Separately)
3. Point the remote control with its emitter
window toward the front of the camera
and press • or 2s button.
• Release (•): the remote-control lamp will blink
once, and the picture is taken immediately.
• Delay (2s): the remote-control lamp will blink
for two seconds before the picture is taken.
• Remote control mode will remain selected after
the picture is taken.
• To save power, the data panel will shut off and
the lens will retract if the remote control is not
operated for more than eight minutes.
1. Place the camera on a tripod, then press
the remote-control button until appears
in the data panel.
2. Compose your picture.
Continued on following page.
The IR Remote Control RC-3 (not included)
allows remote camera operation from up to 5m
(16 ft.) away.
• The distance may be shorter or the remote
control may not operate with backlit subjects,
under fluorescent light, or in extremely bright
lighting conditions.
Emitter window
Delay button
Release button
To Next Page
Loading...
