14 15
INSTALLING THE BATTERY CHECKING THE BATTERY
Your camera uses one 3-volt CR-2 lithium battery
to supply power for all camera operations.
1. Turn the camera upside down, then open
the battery chamber as shown, using the
bigger button key on the strap.
2. Insert the battery into the chamber as
indicated by the + and – marks.
3. Close the battery chamber, then turn the
lock until it stops at CLOSE.
• After installing a new battery, reset the date and
time (p. 50).
Each time the lens cover is opened, a symbol will appear in the data panel
to indicate the power status of the battery.
Briefly appears. Power is sufficient for all camera
operations.
Power is sufficient, but the battery must be
replaced soon.
Replace the battery. The shutter will lock until the
battery is replaced.
Continued on following page.
To Next Page
Loading...
