MINOURA moz-roller - Important Notes

!
!
!
!
!
!
!
!
!
!
!
- 2 -
IMPORTANT NOTES
● Read this instruction manual carefully and keep them for future reference.
● This product requires assembly. Mind each caution below.
● This product is made to be assembled one way only. Any modication or change from the
supplied instructions will void the warranty.
● A 1-year warranty is provided for this product. Please refer to the enclosed warranty card
for more details.
For standard 2-wheel bicycle with a wheelbase between 950 and 1,090mm only. No other bikes (including
small wheel bikes and BMX) can be used on this product.
We don't recommend using this product with a recumbent bike because its riding position is so special that it's
hard to keep correct balance. If you use a recumbent, you do so at your own risk.
It's dangerous to remove your hands from handlebar while riding on rollers. Place your both hands on the
handlebar gently (do not grab hard) at all times. Do not look down, and try to look 2 – 3 meters ahead for safe
riding.
Adjust the front roller position properly in the best position for your bike's wheelbase.
If the front roller is located too far forward, the handling performance on the front end will be unstable and you may
fall easily. If the bike is too far back, stability will decrease.
Make sure you are positioned several inches off the oor. Being on rollers mean you won't be able to reach the
oor in the same way as if you aren't on rollers. While supporting yourself, nd the best place to put your foot down
when needed. If you have cleats on your shoes, be extra careful not to slip on the frame or the oor. An optional
foot step is available for added safety.
It's dangerous to touch the spinning roller or belt. Keep small children and pets away from the rollers while workout.
Keep any sharp and fragile items away from the rollers to prevent any unexpected accident.
Before each use, make sure all bolts and nuts are properly tightened.
Do not adjust the bolts on the end of the rollers. This could cause serious damage to the rollers.
Do not over tighten the Dome Nut. This will cause the inside metal collar to deform, and ruin the at washer which
could result in serious injury.
Set the Roller Belt properly on the grooves found on the roller drum end caps. You cannot ride on rollers without
this belt. Check the belt before every use. If the belt becomes worn or frayed, replace it immediately.
Be careful not to pinch your nger when folding down the frame. Do not stand on the roller drums.
Rollers do not offer any support. You must learn to keep your balance while on the rollers. Place the rollers on a
at surface and near a hand rail or something you can hold onto until you can gain your balance on the rollers.
If you don't install the optional Mag resistance unit on the frame, remove the mag unit V-belt to avoid any risk of an
accident.
Set the air pressure 10% higher than usual. If it's too low, squealing will occur.
If the tire is wet, it will slip and that is dangerous. Always wipe any moisture away before use.