35
Connecting the fl ash module
(DSC Flash) to the camera (DSC)
Switch both the camera and the fl ash module off
before connecting the external fl ash to the DSC.
Hold the fl ash module with the monitor facing
upward next to the DSC with the camera controls
facing upward. Now join the two units so that
the connector of the fl ash fi ts into the socket of
the camera and the safety chain eye of the DSC
fi ts into the mating opening on the fl ash module.
To connect the two devices simultaneously press
down and gently squeeze the engaging notches.
When doing so, the notches of the fl ash must en-
gage in the corresponding openings on the DSC.
Now move the slide lever on the bottom of the
fl ash fully to the right (into the position “lock”),
until you hear this audibly engage. The fl ash mod-
ule is now fi rmly connected and engaged with
the DSC camera.
To separate the fl ash module and camera again
you must fi rst switch off both units. Move the slide
lever on the bottom of the fl ash into the position
Slide lever Engaging notches
To Next Page
Loading...
Need help?
General
Weight and Dimensions
