Minuteman HM47B - Page 21

6.2 Programming The Drive Controller
• Modify Parameter
In some cases, the 5
-
pin plug of the K3 relay in the machine has to be disconnected
In
some
cases,
the
5
pin
plug
of
the
K3
relay
in
the
machine
has
to
be
disconnected
before programming the controller.
After correct entering of password, the parameter “F..” selected before appears in the display.
Invoke the numeric value of the parameter by pressing the “MODE” key.
M dif thi i l f th l t d t b th “UP/“DOWN” k
M
o
dif
y
thi
s numer
i
c va
l
ue o
f
th
e se
l
ec
t
e
d
parame
t
er
b
y
th
e
“UP/“DOWN”
k
eys.
Acknowledge modification by pressing the “MODE” key.
Then the selected parameter “F..“ is displayed.
• It is possible to quit the parameter mode immediately by simultaneous pressing the “MODE” and
“UP” keys.
The mode is automatically quit after 20 seconds without actuation of key The controller then
•
The
mode
is
automatically
quit
after
20
seconds
without
actuation
of
key
.
The
controller
then
attains its operating mode.
• Viewing parameters is possible without entering the password while modification of parameters
always requires entering of password.
21