Minuteman SCV2832E - Testing the Throttle Potentiometer

10. Testing the Throttle Potentiometer
1. The throttle potentiometer resistance can be measured with an ohmmeter.
2. Unplu
g
the throttle potentiometer at the connector next to it.
g
3. Analog type meters are recommended for this test.
4. Measure the resistance across the red and white wire on the potentiometer assembly. It should
measure approximately 5K (5 thousand ohms).
5. Measure across the black and white wires on the
p
otentiometer, the resistance should be zero
p
ohms with pedal on the riders in the neutral position or speed knob on the ES2832 and CP2832 in
the full counterclockwise position. When the pedal or knob is moved to the full throttle position, in
should be a smooth resistance change without dropping out. It should measure approximately 5K
(5 thousand ohms) in the full position.
6
Mi thblkd
th d i th i t h ld b i t l 5K (5
6
.
M
easur
i
ng across
th
e
bl
ac
k
an
d
th
e re
d
w
i
re
th
e res
i
s
t
ance s
h
ou
ld
b
e approx
i
ma
t
e
l
y
5K
(5
thousand), when in the neutral position. When the pedal is at full throttle or the knob is full speed
position, the resistance should drop to zero.
7. If adjustment is needed, loosen the nut and screw on the throttle arm. Adjust the potentiometer
shaft with a flat tip screw driver, until it is set according to the information above (on the riders
shaft
with
a
flat
tip
screw
driver,
until
it
is
set
according
to
the
information
above
(on
the
riders
only).
Page 36
Potentiometer Assembly
Adjust Here