What to do if the brush does not turn ON on my Minuteman Floor Machine?
If the brush on your Minuteman Floor Machine isn't turning on, start by checking the circuit breaker in the handle and reset it if it has tripped. Also, ensure the switch is in the ON (I) position. Examine the belt for any damage and replace it if necessary. Finally, check the brush housing for any lodged debris and remove it.
Why is solution recovery reduced in my Minuteman X17?
If there's reduced solution recovery with your Minuteman Floor Machine, start by checking the dome lid filter of the vac float shut off for clogs and rinse out any debris. Ensure the recovery dome lid and recovery tank are seated properly. Verify the recovery tank dump hose is correctly closed by disconnecting and reconnecting the cap. Inspect the gasket on the recovery dome lid for damage and replace if needed. Check the vac shoe for clogs and remove any debris; also, consider replacing the vac shoe if it's worn.
What to do if no water is dispensed from spray jets on my Minuteman X17 Floor Machine?
If no water is dispensed from the spray jets of your Minuteman Floor Machine, check the following: 1. Reset the circuit breaker in the handle, if tripped. 2. Open the solution tank in-line filter valve, if closed. 3. Ensure the sprayjet switch is in the ON (I) position. 4. Fill the solution tank if it's empty.
Why is the spray intermittent or streaked on my Minuteman Floor Machine?
If the spray from your Minuteman Floor Machine is intermittent or streaked, inspect the solution hoses for clogs or kinks; remove any debris and replace any kinked hoses. Clean the solution tank in-line filter valve thoroughly. Also, remove and clean the spray jets, being careful not to damage them by using pins or wires.
What to do if the vacuum motor does not start on my Minuteman X17?
If the vacuum motor on your Minuteman Floor Machine doesn't start, first check if the circuit breaker in the handle has tripped and reset it. Ensure the switch is in the ON (I) position. If these steps don't resolve the issue, the motor carbon brush may be worn, and you should contact a qualified service technician.
Details voltage and amp requirements for operation.
Explains proper grounding procedures to prevent shock.
Description and function of the control panel elements.
Daily maintenance tasks for the machine.
Scheduled maintenance tasks by frequency.
How to properly fill the machine's solution tank.
Steps to prepare the carpet before cleaning.
General| Brand | Minuteman |
|---|---|
| Model | X17 |
| Category | Floor Machine |
| Language | English |
To Next Page