Minuteman X17 - Unpacking Instructions; Electrical Requirements; Grounding Instructions

6
© 2015 Minuteman International, Inc.
X17 ECO CFS Carpet Extractor #988751UM Rev. * 04/15
INSPECTION
Carefully unpack and inspect your machine for shipping damage.
Each unit is tested and thoroughly inspected before shipment, and
any damage is the responsibility of the delivery carrier who should be
notied immediately.
ELECTRICAL
Model Numbers X17115Z / X17115HPZ are designed to operate on
a standard 15 amp. 115 volt, 60 hz, AC circuit. Voltages below 105
volts AC or above 125 volts AC could cause serious damage to the
motor.
Model Numbers X17230Z / X17230HPZ are designed to operate on
a standard 10 amp. 230 volt, 50 hz, AC circuit. Voltages below 210
volts AC or above 250 volts AC could cause serious damage to the
motor.
WARNING
Electric motors can cause explosions when operated near explosive
materials or vapors. Do not operate this machine near ammable
materials such as solvents, thinners, fuels, grain dust, etc.
GROUNDING INSTRUCTIONS
This oor-nishing machine shall be grounded while in use to protect
the operator from electric shock. The machine is provided with a
three-conductor cord and a three-contact grounding type attachment
plug to t the proper grounding type receptacle. The green (or green
and yellow) conductor in the cord is the grounding wire. Never
connect this wire to other than the grounding pin of the attachment
plug.
DANGER
Improper connection of the equipment-grounding conductor can result in a risk
of electric shock. Check with a qualied electrician or service person if you are
in doubt as to whether the outlet is properly grounded. Do not modify the plug
provided with the appliance — if it will not t the outlet, have a proper outlet
installed by a qualied electrician.
Model Numbers X17115Z / X17115HPZ are for use on a nominal 115-volt
circuit and has a grounding plug that looks like the plug illustrated in Figure 1.
Model Numbers X17230Z / X17230HPZ are for use on a nominal 230-volt
circuit and has a grounding plug that looks like the plug illustrated in Figure 2.
Make sure that the appliance is connected to an outlet having the same
conguration as the plug. No adapter should be used with this appliance.
Unpacking Instructions
Figure 1
Figure 2