MIRAGE SYSTEMS G4 - Distributing Remaining Bridle; Threading Pull Up Cord through Pilot Chute; Compressing the Pilot Chute

10
Packing the Reserve Container
Distribute the remaining !"# ft of bridle on top of the
$% closing flap&[Fig& '#]
Thread pull up cord through the spring pilot chute&
Center the pilot chute base over the $% closing flap
grommet& [Fig& '(]
While keeping all pilot chute fabric out of the spring)
compress the pilot chute& [Fig& '*]
Helpful Hint: Holding the pull up cord in your mouth
will help control the spring& The pull up cord helps guide
the pilot chute while you compress it with your hands&
Fig& '#
Fig& '(
Fig& '*
MIRAGE SYSTEMS