22
Assembly of Centerline
Collapsible Pilot Chute
Set out your main canopy! main bag and new pilot
chute" Find the bridle attachment point on your main
canopy [Fig" #]"
Remove the $% Rapid link from the bridle" Be sure to
unscrew the barrel fully! that will help you installing it
later"
Feed the end of the bridle through the grommet in the
top of the main bag from the outside in" Fold the bridle
if necessary and push the two short loops of fabric (one
covered in yellow Kevlar tape) through the grommet as
well" About #” (&"' cm) should protrude through to the
inside of the main bag [Fig" &]
Guide the open $% Rapid link through the fabric loop
which is backed with yellow Kevlar tape [Fig" (]
Fig" #
Fig" &
Fig" (
MIRAGE SYSTEMS
To Next Page