31
User Instructions
HOW TO PUT THE HARNESS/CONTAINER ON!
When putting on your Mirage" first place your arms
through the main lift web! The container should be
resting on your shoulders! Next" slip the legstraps on!
Thread the chest strap through the adapter! [Fig!#]
IMPORTANT:
Make sure the leg straps and chest strap
are threaded properly through the friction adapters! If
you have any question consult your rigger or instructor!
Next" tighten the chest strap until the harness yoke is
parallel over your shoulders! Stow excess webbing in
elastic keeper! [Fig! $]
Fig #
Fig $
Fig %
Next" tighten the legstraps until they are comfortable!
Helpful Hint: Leaning forward slightly while tightening
will provide an even tighter fit! The container tends to
slide down the back before the leg straps are tightened!
Leaning forward while cinching the leg straps allows
the user to move the container further up their back!
[Fig! 3]
MIRAGE SYSTEMS
To Next Page
Loading...