Need help?Do you have a question about the Mirage KP-2 Series and is the answer not in the manual?
Lists associated parts shipped with the KP-2 unit, including control unit, U-bolt, cradle, and nuts.
Explains the function of the KP2RC unit, powering the pre-amp via RF line and enabling automatic switching.
Details frequency coverage, gain, noise figure, power requirements, and connector types for KP-2 models.
Provides step-by-step instructions for mounting the KP-2 pre-amplifier on a 1-3/4" antenna mast.
Details how to install the KP2RC control unit, connecting it between the radio and antenna via coax.
Instructions on how to adjust the pre-amplifier gain level to HIGH for very weak signal reception.
Provides contact information and advice for obtaining technical support for the unit.
To Next Page
General