Miroir M40 - BATTERY CHARGING INSTRUCTIONS; OPERATING THE PROJECTOR; PROJECTOR SETUP AND POWER

13
charging the Battery
1. The built-in battery is charged using the included Micro USB to
USB cable. The blue system indicator light will come on if the
battery power is getting low.
iMPortant: Fully charge the battery before the first use
(approximately 3-4 hours).
oPerating the Projector
seTup
1. The projector can be powered using the included Micro USB to
USB cable or the built-in battery.
• To power the projector with the Micro USB to USB cable, connect
the Micro USB to the projector’s and plug the other end into a USB
port. Once connected, the power indicator light will illuminate red
on the projector to show it is connected to power.
• To power the projector with the built-in battery, simply turn the
projector on.