14
iMPortant: Fully charge the battery before first use (approximately
3-4 hours).
2. Connect the included HDMI cable to the HDMI port on the
projector and the other end to your device.
note: Some devices may require an adapter to connect to your device.
3. If desired, connect a speaker to the 3.5mm audio out jack. If no
external speaker is connected, the projector’s internal speaker will
be used for audio.
powering up and viewing media
1. Power on the projector by flipping the power switch to the
on position.
2. Allow the projector 15 to 20 seconds to fully start up and sync
with your device.
note:
After syncing with the projector you may see your device’s screen
being mirrored by the projector. Some devices may not have this ability,
but they can still be used with the projector to project videos, photo slide
shows, and some app content (this functionality is app dependent).
To Next Page
Loading...
