17
powering up and viewing Media
IMPORTANT: Before you power on the projector, please be sure to check
that there is nothing blocking the ambient light sensor on the front of the
projector(the location of this sensor can be seen in Locations and Parts
diagram on page 9). Blocking this sensor may impact the IntelliBright
adjustments the projector makes which optimizes the projected image.
1. Power on the projector by pressing and holding the power button for
3 seconds.
2. Allow the projector 15 to 30 seconds to fully start up and make
image adjustments.
•When initially turned on, you will see the Miroir startup screen.
Following that screen, the screen may flicker briefly as DLP IntelliBright
technology built into the projector makes adjustments according to the
ambient light in your environment.
NOTE: After syncing with the projector you may see your device’s screen
To Next Page
Loading...
