10
Drain hose
• When the continuous drain feature is
not being used, remove the drain hose from the
Continuous Drain Port. Reinstall the drain plug,
making sure it is on securely.
Warning: Do not use drain hose in Cooling
mode.
Note: The drain hose must be put lower
than the Continuous Drain Port. water
can not be drained if the hose set higher
than the Continuous Drain Port.
Note: the compressor can only be
restarted after 3 minutes, as a protective
measure against damage to the
compressor unit.
Installation Guide
Location Requirements
In the cooling mode, the appliance must be
placed close to a window or opening so that the
warm exhaust air can be ducted outside.
1. The unit must be stood upright at all
times. Position the unit on a at oor where it is
within reach of a switched power outlet and
make sure there is a minimum of 50cm clearance
around the unit.
2. The extending range of the exible
exhaust hose should not exceed 1.5m (4.92ft).
3. Do not block the air outlet.
4. Place the appliance with it’s unwound
supply cord within reach of the nearest Domestic
Power Outlet.
5. Do not plug supply cord into extension
cords , double adaptors or power boards of any
kind at any time, it should only ever be plugged
directly into Domestic Power Outlet.
Insert batteries into the Remote
Control
1. Press down on the arrow and slide the
battery cover on the back of the remote, then
you can remove the cover.
2. Insert two new AAA 1.5V alkaline
batteries align with polarity indicator markings
(+/-) inside the compartment.
3. Reattach the battery cover, making
sure the locking tab clicks into place.
To Next Page
Loading...
