11
Using the Remote Control to operate
the appliance
1. For the best results, aim the remote
control directly at the Remote Sensor on the front
panel of the appliance.
2. Do not put any objects between
the remote control and the appliance while
operating the appliance.
3. Operate the remote control within a
5-metre range and an angle of 60 degrees.
Notes:
1. Use only alkaline batteries. Do not
use rechargeable batteries. Keep
batteries out of children’s reach.
2. Do not use old and new or different
types of batteries in combination. Do
not use the remote if the batteries
have leaked.
3. Remove the batteries if they are
discharged or if the remote control
is not being used for a long time.
Don’t let the drained battery acid
discharge damage the remote
control.
4. When there is a strong ambient
light source, the performance of
the infrared remote sensor may
be degraded, causing unreliable
operation.
5. Batteries contain chemical
substances, so they should be
disposed of properly.
How To Assemble The
Window Slider Kit
1. Disassemble the screw, washer and
nut.
2. Separate 2 pieces of the slide bar and
insert the screw into the hole.
3. Assemble the slide kit.
4. Adjust the length of window slider kit
as per your window and tighten the washer and
nut.
5. The Window Slider Kit (Minimum: 93cm
Maximum: 125cm) has been designed to t most
standard vertical and horizontal sliding window
applications.
To Next Page
Loading...
