Mitel ST100DA - Connections; Connecting the Mitel Voice Switch to the Network; Powering on the Mitel Voice Switch

Connections
Use an RJ-45 Ethernet cable to connect one or both of the LAN ports
to the network subnet.
While both ports can detect and respond to link status, the switch cre-
ates a data connection on only one LAN port at a time.
Connecting the Mitel Voice Switch to the Network
OncetheST100DAVoiceSwitchissecuredtoarackorplacedonasurface,youcanconnectitto
the data network.
Servicing Procedures
WARNING:TheST100DAcontainsnointernaleldserviceableparts.ReturntheequipmenttoMitel
for any required service procedures.
CAUTION:InternalfusesshouldbeservicedonlybyqualiedMitelpersonnel.Ifinternalfusesare
blown and require replacement, return the ST100DA to Mitel for service.
WARTUNGSVERFAHREN
ACHTUNG:DerST100DAenthältkeineinternenTeile,dievorOrtgewartetwerdenkönnen.Senden
Sie das Gerät an Mitel, falls Wartungsarbeiten erforderlich sein sollten.
VORSICHT:InterneSicherungendürfennurvonqualiziertenMitel-Mitarbeiterngewartetwerden.
Wenn interne Sicherungen ausgetauscht werden müssen, senden Sie den ST100DA zur Wartung an
Mitel.
Powering on the Mitel Voice Switch
After connecting the switch to the network, power on the device by connecting it to an AC power
source.
1. Plug an AC surge protector (not provided) into a grounded AC power source.
2. Plug one end of the provided power cord into the receptacle on the back of the switch, then
plug the other end into the AC surge protector.
ThepowerLEDashesmomentarily,andremainslit.
• If the LED is not lit, make sure the power cord is plugged into the switch and the power source.
• IftheLEDcontinuesashing,thereisaninternalerror.Unplugtheswitchtopoweritoff,then
poweritbackon.Refertothe“ConguringSwitches”chapterintheMitel Connect System
Administration Guideforinformationonashpatterns,orcontactMitelSupportServicesat
http://www.mitel.com/shoretel.
The LAN ports auto-sense the network transport rate. When the network connection is established,
the network LED indicates a transport rate of 10, 100, or 1000 Mbps, and whether the switch is
receiving and transmitting data.