Running In
During the rst ten hours of work, avoid running the engine at maximum speed for a prolonged period until
all the components have bedded in, after the engine has been run in, it will reach its maximum power.
Transportation
Never transport the Multi-Tool with the engine running. An engine that is running could be accidently
accelerated causing the cutter head to engage.
Make sure the blade safety guards are in place when transporting the Multi-Tool.
When carrying by hand, the cutting head should be pointing backwards.
Ensure the Multi-Tool is secure when transporting in a vehicle and the tank is drained of fuel.
Maintenance
IMPORTANT
After every use, check that all nuts, bolts and screws are securely fastened and tighten if necessary.
In the event of an accident, breakdown or blockage, ensure the engine is turned o before any work is
carried out to rectify this.
Make sure the engine has stopped and is cool before performing any service to the machine. Contact with a
moving cutting head or hot muer may result in a personal injury.
Fuel Filter
Every 15 hours of operation, using a wire hook, take the
fuel lter from the fuel tank and clean or replace with
a new fuel lter.
To Next Page
Loading...
