Spark Plug
Poor starting or misring is often caused by a fouled or defective
spark plug, clean and reset the gap to 0.65 mm, or replace the spark
plug with NGK: BPMR7A as necessary.
Air Filter
Before using the Multi-Tool, check the air lter (a).
A clogged air lter will reduce the engine performance.
Remove the air lter cover by undoing the cover screw
clean the lter element in warm, soapy water and
dry completely before installing. If the element is broken
or shrunk, replace with a new one.
Carburettor
The carburettor mixture setting has been set at the factory and will
not need adjusting.
Adjusting the idle speed. If adjustment is necessary turn the T screw
(b) clock wise until the cutter head starts to move, then turn the
screw T anticlockwise until the cutter head stops.
If the idle speed cannot be adjusted to stop the cutting head
moving at idle, contact your dealer for repair before use.
Safety Lock
The safety lock is to prevent the throttle lever from accidentally
being engaged. The throttle lever (c) can only be pressed in if the
safety lock (d) is held down. Check if the safety lock and throttle
lever returns to its original position and the engine returns to idling
when you release your hand from the handle.
Any defects contact your nearest service agent for repairs
before using the machine.
(a)
(b)
(c)
(d)
To Next Page
Loading...
