Spark Plug
Poor starting or misfiring is often caused by a fouled
or defective spark plug, clean and reset the gap to
0.65 mm, or replace the spark plug with LD L8RTF;
CHAMPION RCJ7Y; NGK BPMR7A as necessary.
Air Filter
Before using the Multi-Tool, check the air filter (a). Being clogged, will reduce the engine
performance. Remove the air filter cover by pressing on the filter cover release (b) and opening
the filter cover (c). Clean the filter element in warm, soapy water, dry completely before installing.
If the element is broken or shrunk, replace with a new one.
Storage
• Remove the spark plug, pour a small amount of oil into the cylinder. Rotate the crankshaft
several times using the starting rope in order to distribute the oil. Put the spark plug back in.
• Remove the fuel from the machine.
• Check the Multi-Tool for damage or problems at the intervals shown in the service schedule.
Hedgetrimmer Blades
• After each session of operation, oil the cutting blades with light oil.
Gearbox Lubricant
• DO NOT force grease into the gear boxes, apply 2 or 3 pumps of grease every 15 hours of
operation.
To Next Page
Loading...
