TROUBLESHOOTING
PROBLEM PROBABLE CAUSE REMEDY SUGGESTED
Fails to split logs Log is improperly positioned Refer to" Log Splitter Operation" section
for perfect log loading
The size or hardness of the log exceeds
the capacity of the machine
Reduce the log size before splitting it on
the log splitter
Wedge cutting edge is blunt Refer to " Sharpening Wedge" section to
sharpen the cutting edge
Oil leaks Locate leak(s) and contact the dealer
The log pusher moves jerkily, making
unfamiliar noises or vibrating a lot.
Lack of hydraulic oil and excessive air in
the hydraulic system
Check oil level for possible oil relling.
Contact the dealer
Oil leaks around cylinder ram or from
other points.
Air sealed in hydraulic system while
operating
Loosen Bleed Screw by 3-4 rotations
before operating the log splitter
Bleed Screw is not tightened before mov-
ing the log splitter
Tighten the Bleed Screw up before mov-
ing the log splitter
Oil Drain Bolt with Dipstick is not tight Tighten the Oil Drain Bolt with Dipstick
Hydraulic Control Valve Assembly and /
or seal(s) worn
Contact your dealer
If the solutions above fail to resolve the problem or the machine is not safe to use then contact the suppying dealer.
To Next Page
Loading...