mitrefinch T2 - Page 14

13
There are 2 modes
Push and release to force a reboot.
1
Push and hold to enter factory reset mode. The T2 will reboot and offer
you three options:
2
Reset to factory
This will erase the current cong and boot from an safe version of the
operating system. Software updates will be required to bring the T2 back to
current version.
Revert to previous version
This will revert to the last production certied Mitrench software version.
Restore current version
This will re-install the current version.
Note: The factory reset option will erase the T2 and require it to be
registered again. The current cong and user data will be restored back to
the device after re-registering.