6
At this point the unit will need adding to the network. This is covered in ‘Network settings
and hardware’ on page 13.
This stage of commissioning is undertaken by a Mitrench specialist and we do not
recommend a customer attempt to add the unit to their network, until fully trained
by a Mitrench specialist to do so.
Cabling and physical installation options
The T2 supports a wide variety of installation options. If installed correctly the T2 can
offer full IP66 water and dust ingress protection to support use both outside and in
environmentally challenging environments.
The unit may be powered by Power over Ethernet or a dedicated low voltage DC power
supply. Mitrench only recommend the use of a Mitrench supplied and certied power
supply with Mitrench hardware.
To Next Page
Loading...