Mitsubishi Electric a2 Series - Page 84

α 2 Simple Application Controllers
Function Blocks 6
6 - 30
2 ) Press the “OK” key with the cursor in the function block. The function block edit screen is
displayed as shown
3 ) Highlight “Setup FB” and press “OK”.
4 ) Highlight “InputVal” and press “OK”.
5 ) If a constant output voltage is required, highlight “DirectSet” and press “OK.” If not, skip to
step 7.
6 ) Enter a Direct Set value using the “+ and -” keys and press the “OK” key to accept the
value. Skip to Step 11.
7 ) If an analog input will be used, highlight “AnalogIn” and press “OK.” If not, skip to step 9.
8 ) Select the appropriate analog input and press “OK. Skip to Step 11.”
9 ) If an FB word output will be used as the input value for the Analog Output FB, highlight “FB
Value” and press “OK.” If not, skip to step 11.
B001 :CN
Se t up FB
Change No
De l e t e FB
I npu t lV
Channe l
B001 : AO
a
Di rec tS
Ana l og I
FB Va l ue
B001 : AO
et
n
Ana l o tO
Di rectS
0
B001 : AO
ug
et
Input lV
Channe l
B001 : AO
a
Ana l o tO
Ana l og I
0
B001 : AO
ug
n
A01
I npu t lV
Channe l
B001 : AO
a
Ana l o tO
Coun t e r
2
B001 : AO
ug
B00