How to reset Mitsubishi Electric A800 Inverter?
To reset the Mitsubishi Electric Inverter, you can: * Press the reset button on the operation panel (available only when a fault occurs). * Switch the power OFF and then ON again. * Turn ON the reset signal (RES) for at least 0.1 s.
General| Series | A800 |
|---|---|
| Type | Inverter |
| Overload Capacity | 150% for 60 seconds |
| Operating Temperature | -10°C to +50°C |
| Output Voltage | 0-Input Voltage |
| Power Rating | 0.4 kW to 560 kW |
| Control Method | V/f control, vector control |
| Braking Unit | Optional |
| Communication Protocols | Modbus, CC-Link, Profibus |
| Protection Features | Overcurrent, Overvoltage, Undervoltage, Ground fault |
| Storage Temperature | -20°C to +60°C |
| Humidity | 95% RH or less (non-condensing) |
| Input Voltage | 3-phase 200V to 240V, 380V to 480V |
| Output Frequency | 0.1-400 Hz |
| Frequency Range | 0.1-400 Hz |
To Next Page
