Mitsubishi Electric A800-E User Manual

INVERTER A800-E / F800-E
ETHERNET FUNCTION MANUAL
B
Ethernetcommunicationfunction
800 800
IB(NA)-0600628ENG-B(1611)MEE Printed in Japan Specifications subject to change without notice.
ETHERNET FUNCTION MANUAL
This manual explains the Ethernet communication specifications. For the functions not found in this manual, refer
to the Instruction Manual (Detailed) of the FR-A800/FR-F800 inverter.
In addition to this manual, please read the Instruction Manual (Detailed) of the FR-A800/FR-F800 inverter
carefully. Do not use this product until you have a full knowledge of the equipment, safety information and
instructions.
Please forward this manual to the end user.
INVERTER
A800-E / F800-E
HEAD OFFICE: TOKYO BUILDING 2-7-3, MARUNOUCHI, CHIYODA-KU, TOKYO 100-8310, JAPAN

Mitsubishi Electric A800-E Specifications

General

Type	Inverter
Overload Capacity	150% for 60 seconds
Cooling Method	Forced Air Cooling
Enclosure Rating	IP20
Control Method	Vector control, V/f control
Rated Output Power	0.4 kW
Frequency Range	0.2 to 590 Hz
Communication Protocol	Modbus RTU, Ethernet
Braking Unit	Built-in
Protection Features	Overcurrent, Overvoltage, Overheat
Operating Temperature	-10°C to +50°C
Storage Temperature	-20°C to +65°C
Humidity	95% RH or less (non-condensing)

Summary

Introduction to Ethernet Communication

Ethernet Communication Overview

Details the inverter's Ethernet board and its role in network communication.

Ethernet Connector Specifications

Information on Ethernet connector type, speed, segment length, and interface standards.

Ethernet Cable Wiring Precautions

Essential guidelines for handling and connecting Ethernet cables to prevent issues.

Ethernet Board Removal Procedure

Step-by-step instructions for safely removing the Ethernet communication board.

Parameter Configuration and Ethernet Operation

Parameter List by Number

Comprehensive list of Ethernet communication parameters identified by their parameter number.

Parameter List by Function Group

Organized listing of Ethernet communication parameters categorized by functional groups.

Operation Command and Frequency Control

Parameters governing command source selection and motor frequency/torque control.

Monitor Display and Output Signal Configuration

Settings for monitoring inverter status and configuring output signals.

Operation via Communication Settings

Parameters essential for configuring and managing various communication operations.

Protective Functions and Troubleshooting

Causes and Corrective Actions for Protective Functions

Identifies causes and provides corrective actions for protective function activations and faults.

Inverter Specifications and Control Method Parameters

Common Inverter Specifications

General specifications including control methods, frequency ranges, and input/output signals.

Parameters and Instruction Codes by Control Method

Details parameter availability and instruction codes for various inverter control methods.