J
Jennifer BrownSep 8, 2025
What does E.ILF* Major fault mean on Mitsubishi Electric FR-F 700 EC?
- KKelly CarrollSep 9, 2025
The E.ILF* major fault on your Mitsubishi Electric DC Drive indicates an input phase failure.
To Next PageTo Next PageWhat does E.ILF* Major fault mean on Mitsubishi Electric FR-F 700 EC?
The E.ILF* major fault on your Mitsubishi Electric DC Drive indicates an input phase failure.
What does E.OC1 Major fault mean on Mitsubishi Electric FR-F 700 EC DC Drives?
The E.OC1 major fault on your Mitsubishi Electric DC Drive indicates an overcurrent shut-off occurred during acceleration.
What does E.OC2 Major fault mean on Mitsubishi Electric FR-F 700 EC?
The E.OC2 major fault on your Mitsubishi Electric DC Drive indicates an overcurrent shut-off occurred during constant speed.
What does E.OC3 Major fault mean on Mitsubishi Electric FR-F 700 EC?
The E.OC3 major fault on your Mitsubishi Electric DC Drive indicates an overcurrent shut-off occurred during deceleration or stop.
What does E.OV1 Major fault mean on Mitsubishi Electric FR-F 700 EC?
The E.OV1 major fault on your Mitsubishi Electric DC Drive indicates a regenerative overvoltage shut-off occurred during acceleration.
What does E.OV2 Major fault mean on Mitsubishi Electric FR-F 700 EC?
The E.OV2 major fault on your Mitsubishi Electric DC Drive indicates a regenerative overvoltage shut-off occurred during constant speed.
What does E.OLT Major fault mean on Mitsubishi Electric FR-F 700 EC DC Drives?
The E.OLT major fault on your Mitsubishi Electric DC Drive indicates stall prevention.
What does E.UVT Major fault mean on Mitsubishi Electric FR-F 700 EC DC Drives?
The E.UVT major fault on your Mitsubishi Electric DC Drive indicates undervoltage.
What does E.FIN Major fault mean on Mitsubishi Electric DC Drives?
The E.FIN major fault on your Mitsubishi Electric DC Drive indicates a fin overheat.
What does E.IPF Major fault mean on Mitsubishi Electric DC Drives?
The E.IPF major fault on your Mitsubishi Electric DC Drive indicates an instantaneous power failure.
General| Category | DC Drives |
|---|---|
| Cooling Method | Forced air cooling |
| Type | Inverter |
| Output Frequency | 400 Hz |
| Horsepower Range | 0.5 HP |
| Control Method | V/F control |
| Rated Output Current | Varies by model (refer to specific model datasheet) |
| Overload Capacity | 150% for 60 seconds, 200% for 3 seconds |
| Braking Unit | Built-in |
| Communication | RS-485 |
| Ambient Temperature | -10°C to +50°C (14 to 122°F) |
| Storage Temperature | -20°C to +65°C (-4°F to 149°F) |
| Humidity | 95% or less (non-condensing) |
| Altitude | Up to 1000m (3300ft) above sea level |
| Protection | Overcurrent, Overvoltage, Undervoltage, Overheating, Short Circuit |
| Protection Level | IP20 |
