7 PARAMETER SETTINGS
7.3 Basic Setting
35
7
C061H System error • Check the precautions for the function executed.
• Check the operating status and connection status of the target device.
• Check the connection of the Ethernet cable and the hub.
• Check the line status of Ethernet.
• Reset the CPU module and target device, and execute the function again.
If the above actions do not solve the problem, contact the manufacturer of
the target device.
CEE0H The detection or another online function was executed by
another peripheral.
Execute the other function after the automatic detection of connected
devices is completed.
CEE1H and CEE2H System error • Check the precautions for the function executed.
• Check the operating status and connection status of the target device.
• Check the connection of an Ethernet cable and a hub.
• Check the line status of Ethernet.
• Reset the CPU module and target device, and execute the function again.
If the above actions do not solve the problem, contact the manufacturer of
the target device.
CF10H
CF20H • The setting value of the communication setting is out of
range.
• Items of communication setting which cannot be set on
the target device are set.
• The required setting items have not been set to the
target device.
Correct the setting details, and retry the operation.
CF30H The parameter which is not supported by the target
device was specified.
Check the version of the target device.
CF31H System error • Check the precautions for the function executed.
• Check the operating status and connection status of the target device.
• Check the connection of the Ethernet cable and the hub.
• Check the line status of Ethernet.
• Reset the CPU module and target device, and execute the function again.
If the above actions do not solve the problem, contact the manufacturer of
the target device.
CF50H
CF51H The function cannot be executed because the function
from another peripheral is being executed.
Execute the function again after a while.
CF53H to CF56H System error • Check the precautions for the function executed.
• Check the operating status and connection status of the target device.
• Check the connection of the Ethernet cable and the hub.
• Check the line status of Ethernet.
• Reset the CPU module and target device, and execute the function again.
If the above actions do not solve the problem, contact the manufacturer of
the target device.
CF70H An error has occurred on the Ethernet communication
path.
• Check the operation of the target device.
• Check if the connection cable is disconnected.
CF71H Timeout error • Check the precautions for the function executed.
• Check the operation of the target device.
• Since there may be congestion of packets on the line, send data after a
certain period of time.
Error code Error details and cause Action
To Next Page
Loading...
